Hello

When we try to use variables in Conditions, the step doesn't run correctly, it doesn't find anything.

  visualcron.png (284kb) downloaded 48 time(s).

If instead of this one: "Job {JOB(Active|Variable|vSAPJob)} Step 1" we use this: "Job ES1SAPFIAR958-01 Step 1", the job runs without problems.
Variable vSAPJob is stored as "ES1SAPFIAR958-01".

Could you check it please?

Regards,

Please test this build:

https://www.visualcron.c....aspx?g=posts&t=9330 

---

Good morning,

I have been installed 8.4.2 version, and the problem persist.

Here you are the variable definition:


Task condition config:


The output:


Instead using variables:

Unfortunately we cannot reproduce this. There _was_ a problem because Variables were not resolved causing this. But now it works. Please test with Subject only and "Contains%" to see if that works.

---