an on success interface that may be the point to put the condition point into
and i hope this interface would include a go to task function and a end job function.

What options would you like to see in the "On success" tab of Task?

---

Hi,

I've seen this request befor by support: look here 

I think it would be the same as the on error tab.

Regards
Erik

---

I'm not sure if this is overly helpful, but I've accomplished a work-around for a "on success, end job" function. For example, the scenario "Run Task 1, on success, exit. Otherwise, continue to Task 2." You can inactivate Task 2 (so if it's the last task it will end the job on success) then on the "on error" tab of Task 1, specify "Go to Task 2." This will still run Task 2 like you would expect.

I've only done this with a job with 2 tasks, and I realize that it wouldn't work so perfectly if there were more tasks, but I'm confident I could find a workaround for that too, given enough time.

The On Success tab would make it easier though! Good suggestion.

sorry i have not looked at this application for about 6 months.
but from memory it was something like
if success -> preform logic -> perform job a) b), c) or exit program

sorry i have not looked at this application for about 6 months.
but from memory it was something like
if success -> preform logic -> perform job a) b), c) or exit program

You should really look at it more often 😁 - a lot of things are happening all the time.

---

This has been further improved in version 7.0.0.

---